Specifications

set radius server
Chapter 16
RADIUS and Server Groups Commands
507
Defaults Default values are listed below:
address ip-address IP address of the RADIUS server. Enter the address in
dotted decimal notation.
auth-port
port-number
UDP port that the UNIVERGE WL Controller uses for
authentication and authorization.
acct-port
port-number
UDP port that the UNIVERGE WL Controller uses for
accounting.
timeout seconds Number of seconds the UNIVERGE WL Controller waits
for the RADIUS server to respond before retransmitting.
You can specify from 1 to 65,535 seconds.
retransmit number Number of transmission attempts made before declaring an
unresponsive RADIUS server unavailable. You can specify
from 1 to 100 retries.
deadtime minutes Number of minutes the UNIVERGE WL Controller waits
after declaring an unresponsive RADIUS server
unavailable before retrying that RADIUS server. Specify
between 0 (zero) and 1440 minutes (24 hours). A zero
value causes the UNIVERGE WL Controller to identify
unresponsive servers as available.
key string |
encrypted-key
string
Password (shared secret key) the UNIVERGE WL
Controller uses to authenticate to RADIUS servers. You
must provide the same password that is defined on the
RADIUS server. The password can be 1 to 64 characters
long, with no spaces or tabs.
•Use the key option to enter the string in its unencrypted
form. UNIVERGE WL Control Systemr encrypts the
displayed form of the string in show config and show
aaa output.
• To enter the string in its encrypted form instead, use the
encrypted-key option. UNIVERGE WL Control
Systemr does not encrypt the string you enter, and
instead displays the string exactly as you enter it.
author-password
password
Password used for authorization to a RADIUS server for
MAC authentication. The client’s MAC address is sent as
the username and the author-password string is sent as the
password. Specify a password of up to 32 alphanumeric
characters with no spaces or tabs.