Specifications
set radius client system-ip
Chapter 16
RADIUS and Server Groups Commands
506
set radius client system-ip
Causes all RADIUS requests to be sourced from the IP address specified by the
set system ip-address command, providing a permanent source IP address for
RADIUS packets sent from the UNIVERGE WL Controller.
Syntax
set radius client system-ip
Defaults
None. If you do not use this command, RADIUS packets leaving the
UNIVERGE WL Controller have the source IP address of the outbound interface,
which can change as routing conditions change.
Access
Enabled.
Usage
The UNIVERGE WL Controller system IP address must be set before you
use this command.
Examples
The following command sets the UNIVERGE WL Controller system
IP address as the address of the RADIUS client:
PROMPT# set radius client system-ip
success: change accepted.
See Also
l clear radius client system-ip on page 501
l set system ip-address on page 36
set radius server
Configures RADIUS servers and their parameters. By default, the UNIVERGE
WL Controller automatically sets all these values except the password (key).
Syntax
set radius server server-name [address ip-address] [auth-port
port-number] [acct-port port-number] [timeout seconds] [retransmit number]
[deadtime minutes]
[[key string] | [encrypted-key string]]
[author-password password]
server-name Unique name for this RADIUS server. Enter an
alphanumeric string of up to 32 characters, with no blanks.