Specifications

clear radius client system-ip

Chapter 16

RADIUS and Server Groups Commands

501

success: change accepted.

PROMPT# clear radius timeout

success: change accepted.

See Also

l set radius on page 503

l set radius server on page 506

l show aaa on page 240

clear radius client system-ip

Removes the UNIVERGE WL Controllers system IP address from use as the

permanent source address in RADIUS client requests from the UNIVERGE WL

Controller to its RADIUS server(s).

Syntax

clear radius client system-ip

Defaults

None.

Access

Enabled.

Usage

The clear radius client system-ip command causes the UNIVERGE WL

Controller to use the IP address of the interface through which it sends a RADIUS

client request as the source IP address. The UNIVERGE WL Controller selects a

source interface address based on information in its routing table as the source

address for RADIUS packets leaving the UNIVERGE WL Controller.

Examples

To clear the system IP address as the permanent source address for

RADIUS client requests, type the following command:

PROMPT# clear radius client system-ip

success: change accepted.