Specifications

show security acl info
Chapter 14
Security ACL Commands
473
show security acl info
Displays the contents of a specified security ACL or all security ACLs that are
committed—saved in the running configuration and nonvolatile storage—or the
contents of security ACLs in the edit buffer before they are committed.
Syntax show security acl info [acl-name | all] [editbuffer]
Defaults None.
Access Enabled.
Examples To display the contents of all security ACLs committed on a
UNIVERGE WL Controller, type the following command:
PROMPT# show security acl info
ACL information for all
set security acl ip acl_123 (hits #5 462)
---------------------------------------------------------
1. permit IP source IP 192.168.1.11 0.0.0.255 destination IP any enable-hits
2. deny IP source IP 192.168.2.11 0.0.0.0 destination IP any
set security acl ip acl_134 (hits #3 0)
---------------------------------------------------------
1. permit IP source IP 192.168.0.1 0.0.0.0 destination IP any enable-hits
set security acl ip acl_135 (hits #2 0)
---------------------------------------------------------
1. deny IP source IP 192.168.1.1 0.0.0.0 destination IP any enable-hits
The following command displays the contents of acl_123 in the edit buffer,
including the committed ACE rules 1 and 2 and the uncommitted rule 3:
PROMPT# show security acl info acl_123 editbuffer
ACL edit-buffer information for acl_123
acl-name Name of an existing security ACL to display. ACL names
must start with a letter and are case-insensitive.
all Displays the contents of all security ACLs.
editbuffer Displays the contents of the specified security ACL or all
security ACLs that are stored in the edit buffer after being
created with set security acl. If you do not use this
parameter, only committed ACLs are shown.