Specifications

set security acl map
Chapter 14
Security ACL Commands
468
Defaults None.
Access Enabled.
Usage Before you can map a security ACL, you must use the commit security
acl command to save the ACL in the running configuration and nonvolatile
storage.
For best results, map only one input security ACL and one output security ACL to
each VLAN, physical port, virtual port, or UNIVERGE WL Access Points to
filter a flow of packets. If more than one security ACL filters the same traffic,
UNIVERGE WL Control System applies only the first ACL match and ignores
any other matches.
Examples The following command maps security ACL acl_133 to ap 2 for
incoming packets:
PROMPT# set security acl map acl_133 ap 2 in
success: change accepted.
See Also
l clear security acl map on page 456
l commit security acl on page 458
l set mac-user attr on page 222
l set mac-usergroup attr on page 230
l set security acl on page 460
l set user attr on page 236
l set usergroup on page 238
l show security acl map on page 474
in Assigns the security ACL to traffic coming into the
UNIVERGE WL Controller.
out Assigns the security ACL to traffic coming from the
UNIVERGE WL Controller.