Specifications

show banner motd
Chapter 4
System Services Commands
39
show banner motd
Shows the banner that was configured with the set banner motd command.
Syntax show banner motd
Defaults None.
Access Enabled.
Examples To display the banner with the message of the day, type the following
command:
PROMPT# show banner motd
hello world
See Also
l clear banner motd on page 22
show license
show load
Displays CPU usage on a UNIVERGE WL Controller.
Syntax show load
Defaults None.
Access Enabled.
Examples To display the CPU load recorded from the time the UNIVERGE WL
Controller was booted, as well as from the previous time the show load command
was run, type the following command:
PROMPT# show load
System Load: overall: 2% delta: 5%
Note. This command is not supported.