Specifications

show service-profile
Chapter 12
AP Commands
420
See Also
l set service-profile attr on page 334
l set service-profile auth-dot1x on page 336
l set service-profile auth-fallthru on page 337
l set service-profile auth-psk on page 339
l set service-profile beacon on page 340
l set service-profile cac-mode on page 341
l set service-profile cac-session on page 342
l set service-profile cipher-ccmp on page 343
l set service-profile cipher-tkip on page 343
11a / 11b / 11g transmit
rate fields
Data transmission rate settings for each radio type:
• beacon rate—Data rate of beacon frames sent by
UNIVERGE WL Access Points radios.
• multicast rate—Data rate of multicast frames sent
by UNIVERGE WL Access Points radios. If the
rate is auto, the UNIVERGE WL Access Points
sets the multicast rate to the highest rate that can
reach all clients connected to the radio.
• mandatory rates—Set of data transmission rates
that clients are required to support in order to
associate with an SSID on a UNIVERGE WL
Access Point radio. A client must support at least
one of the mandatory rates.
• standard rates—The set of valid rates that are
neither mandatory nor disabled. These rates are
supported for data transmission from the
UNIVERGE WL Access Points radios.
• disabled rates—Data transmission rates that
UNIVERGE WL Access Points radios will not
use to transmit data. (The radios will still accept
frames from clients at disabled data rates.)
Table 49. Output for show service-profile
Field Description