Specifications

show service-profile
Chapter 12
AP Commands
417
COS CoS value assigned by the UNIVERGE WL Access
Points to all user traffic, if static CoS is enabled. (If
static CoS is disabled, WMM or ACLs are used to
assign CoS.)
Client DSCP Whether packets are classified based on client DSCP
level instead of 802.11 priority.
CAC mode Call Admission Control mode:
• none—CAC is disabled.
• session—CAC is based on the number of active
user sessions. If a UNIVERGE WL Access Point
radio reaches the maximum number of active user
sessions specified in the CAC session field, the
UNIVERGE WL Access Points radio rejects new
connection attempts.
CAC sessions Maximum number of user sessions that can be active
on a UNIVERGE WL Access Point radio at one
time, if the CAC mode is session.
Note: This value applies only when the CAC mode is
session.
User idle timeout Indicates how many seconds a user session can
remain idle (indicated by no user traffic and no reply
to client keepalive probes) before the session is
changed to the Disassociated state.
Idle client probing Indicates whether client keepalive probes are
enabled.
Keep initial VLAN Indicates whether the keep-initial-vlan option is
enabled.
Web Portal Session
Timeout
When a Web Portal Web Authentication session is
placed in the Deassociated state, how many seconds
the session can remain in that state before being
terminated automatically.
Mesh enabled Whether WLAN mesh services are enabled for the
service profile.
Table 49. Output for show service-profile
Field Description