Specifications

show ap unconfigured
Chapter 12
AP Commands
407
See Also
l set ap on page 54
l set ap bias on page 282
l show ap config on page 374
l show ap connection on page 403
l show ap unconfigured on page 407
show ap unconfigured
Displays UNIVERGE WL Access Points that are physically connected to the
network but that are not configured on any UNIVERGE WL Controllers.
Syntax show ap unconfigured
Defaults None.
Access Enabled.
Usage If a UNIVERGE WL Access Points is configured on a UNIVERGE WL
Controller in another Mobility Domain, the UNIVERGE WL Access Points can
appear in the output until the UNIVERGE WL Access Points is able to establish a
connection with a UNIVERGE WL Controller in its Mobility Domain. After the
UNIVERGE WL Access Points establishes a connection, the entry for the
UNIVERGE WL Access Points ages out and no longer appears in the command
output.
Entries in the command output table age out after two minutes.
Examples The following command displays information for two UNIVERGE
WL Access Points that are not configured:
PROPMT# show ap unconfigured
Serial Id: g8tzub0053 Model: WL1500-AP IP Address: 172.16.221.21
Port: 1 Vlan: default
Table 47 describes the fields in this display.