Specifications

show ap global
Chapter 12
AP Commands
405
See Also
l show ap config on page 374
l show ap global on page 405
l show ap unconfigured on page 407
show ap global
Displays connection information for UNIVERGE WL Access Points configured
on a UNIVERGE WL Controller .
Syntax show ap global [ap-number | serial-id serial-ID]
Defaults None.
Access Enabled.
Usage Connections are shown only for the UNIVERGE WL Access Points that
are configured on the UNIVERGE WL Controller from which you enter the
command, and only for the Mobility Domain the UNIVERGE WL Controller is
in.
AP IP Address IP address assigned by DHCP to the UNIVERGE
WL Access Point.
Switch IP Address System IP address of the UNIVERGE WL Controller
on which the UNIVERGE WL Access Point has an
active connection. This is the UNIVERGE WL
Controller that the UNIVERGE WL Access Point
used for booting and configuration and is using for
data transfer.
ap-number Index value that identifies the UNIVERGE WL
Access Points on the UNIVERGE WL Controller.
serial-id serial-ID AP serial ID.
Table 45. Output for show ap connection
Field Description