Specifications

show ap connection
Chapter 12
AP Commands
404
If a UNIVERGE WL Access Points is configured on this UNIVERGE WL
Controller (or another UNIVERGE WL Controller in the same Mobility Domain)
but does not have an active connection, the command does not display
information for the UNIVERGE WL Access Points. To show connection
information for UNIVERGE WL Access Points, use the show ap global
command on one of the UNIVERGE WL Controllers where the UNIVERGE WL
Access Points are configured.
Examples The following command displays information for all UNIVERGE WL
Access Points configured on this UNIVERGE WL Controller that have active
connections:
PROPMT# show ap connection
Total number of entries: 1
AP Serial Id AP IP Address Switch IP Address
--- ----------- --------------- -----------------
3 G8TZUB0028 192.168.1.52 192.168.10.20
The following command displays connection information specifically for a
UNIVERGE WL Access Point with serial ID G8TZUB0028:
PROPMT# show ap connection serial-id G8TZUB0028
Total number of entries: 1
AP Serial Id AP IP Address Switch IP Address
--- ----------- --------------- ---------------
3 G8TZUB0028 192.168.1.52 192.168.10.20
Table 45 describes the fields in this display.
Table 45. Output for show ap connection
Field Description
AP ID assigned to the UNIVERGE WL Access Point.
If the connection is configured on another
UNIVERGE WL Controller, this field contains a
hyphen ( - ).
Serial Id Serial ID of the AP.