Specifications

show ap vlan
Chapter 12
AP Commands
397
show ap vlan
show auto-tune attributes
Displays the current values of the RF attributes RF Auto-Tuning uses to decide
whether to change channel or power settings.
Syntax show auto-tune attributes
[ap ap-number [radio {1 | 2| all}]]
Defaults None.
MAC Address MAC address of the UNIVERGE WL Access Points.
Radio1 State, channel, and power information for radio 1:
• The state can be D (disabled) or E (enabled).
• The channel and power settings are shown as
channel/power.
Radio2 State, channel, and power information for radio 2.
Uptime Amount of time since the AP booted using this link.
Note. This command is not supported.
ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
radio 1 Shows RF attribute information for radio 1.
radio 2 Shows RF attribute information for radio 2. (This option
does not apply to single-radio models.)
radio all Shows RF attribute information for both radios.
Table 41. Output for show ap status terse
Field Description