Specifications

show ap status
Chapter 12
AP Commands
396
bssid, ssid SSIDs configured on the radio and their BSSIDs.
load balance Whether RF load balancing is enabled for the radio
current load The load on this radio relative to the load balancing
group average or target load.
RFID Reports Status of AeroScout asset tag support.
• Active––The AeroScout Engine has enabled the
tag report mode on the UNIVERGE WL Access
Points.
• Inactive––The AeroScout Engine has not
enabled, or has disabled, the tag report mode on
the UNIVERGE WL Access Points.
Note: This field is displayed only if the rfid-mode
option is enabled on the radio profile that manages
the radio.
Table 41. Output for show ap status terse
Field Description
AP The number of the UNIVERGE WL Access Points
connected.
Flag Operational status flags for the UNIVERGE WL
Access Points.
For flag definitions, see the key in the command
output.
IP Address IP address of the UNIVERGE WL Access Points.
The address is assigned to the UNIVERGE WL
Access Points by a DHCP server.
Note: This field is applicable only if the UNIVERGE
WL Access Points is configured on the UNIVERGE
WL Controller as a UNIVERGE WL Access Points.
Model AP model number.
Table 40. Output for show ap status
Field Description