Specifications

show ap status
Chapter 12
AP Commands
393
State State of the AP:
• init—The AP has been recognized by the
UNIVERGE WL Controller but has not yet begun
booting.
• booting—The AP has asked the UNIVERGE WL
Controller for a boot image.
• image downloading—The AP is receiving a boot
image from the UNIVERGE WL Controller.
• image downloaded—The AP has received a boot
image from the UNIVERGE WL Controller and
is booting.
• configuring—The AP has booted and is ready to
receive or is already receiving configuration
parameters from the UNIVERGE WL Controller.
• operational—The AP has received configuration
parameters for one or more radios and is ready to
accept client connections.
• configure failure—One or more of the radio
parameters received from the UNIVERGE WL
Controller is invalid.
For UNIVERGE WL Access Points, this field also
indicates whether the UNIVERGE WL Access
Points management traffic with the UNIVERGE WL
Controller is encrypted, and whether the
UNIVERGE WL Access Points fingerprint has been
verified on the UNIVERGE WL Controller:
• not encrypted—The management session is not
encrypted.
• encrypted but fingerprint not verified—The
UNIVERGE WL Access Points management
traffic is encrypted, but the UNIVERGE WL
Access Points fingerprint has not been verified in
UNIVERGE WL Control System.
State • encrypted and verified—The UNIVERGE WL
Access Points management traffic is encrypted
and the UNIVERGE WL Access Points
fingerprint has been verified in UNIVERGE WL
Control System.
Table 40. Output for show ap status
Field Description