Specifications

show ap config
Chapter 12
AP Commands
374
show ap config
Displays global and radio-specific settings for an AP.
Syntax show ap config [ap-number [radio {1 | 2}]]
Defaults None.
Access Enabled.
Usage UNIVERGE WL Control System lists information for AP.
Examples The following example shows configuration information for an AP
configured on connection 2:
PROPMT# show ap config 2
AP 2: serial-id: 123456789, AP model: WL1500-AP, bias: high, name: AP02
upgrade-firmware: YES
force-image-download: NO
communication timeout: 10
location:
contact:
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 18, profile: default
auto-tune max-power: default,
load-balance-group: ,
load-balance-enable: YES,
force-rebalance: NO,
local-switching: disabled, vlan-profile: default
Table 35 describes the fields in this display.
ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
radio 1 Shows configuration information for radio 1.
radio 2 Shows configuration information for radio 2. (This option
does not apply to single-radio models.)