Manualshelf

Specifications

ManualsBrandsSimplicity ManualsSewing MachineSA2200
371372373374375376377378379380
set service-profile wpa-ie
Chapter 12
AP Commands
372
set service-profile wpa-ie
Enables the WPA information element (IE) in wireless frames. The WPA IE
advertises the WPA authentication methods and cipher suites supported by radios
in the radio profile mapped to the service profile.
Syntax
set service-profile name wpa-ie {enable | disable}
Defaults
The WPA IE is disabled by default.
Access
Enabled.
Usage
When the WPA IE is enabled, the default authentication method is
802.1X. There is no default cipher suite. You must enable the cipher suites you
want the radios to support.
Examples
The following command enables the WPA IE in service profile sp2:
PROPMT# set service-profile sp2 wpa-ie enable
success: change accepted.
See Also
l set service-profile auth-dot1x on page 336
l set service-profile auth-psk on page 339
l set service-profile cipher-ccmp on page 343
l set service-profile cipher-tkip on page 343
l set service-profile cipher-wep104 on page 344
l set service-profile cipher-wep40 on page 346
l show service-profile on page 413
name Service profile name.
enable Enables the WPA IE.
disable Disables the WPA IE.