Specifications

set service-profile transmit-rates
Chapter 12
AP Commands
364
Defaults This command has the following defaults:
l mandatory:
l 11a—6.0,12.0,24.0
l 11b—5.5,11.0
l 11g—1.0,2.0,5.5,11.0
l disabled—None. All rates applicable to the radio type are supported by
default.
l beacon-rate:
l 11a—6.0
l 11b—5.5
l 11g—5.5
l multicast-rate—auto for all radio types.
beacon-rate rate Data rate of beacon frames sent by UNIVERGE WL
Access Points radios.
The valid rates depend on the radio type and are the
same as the valid rates for mandatory. However,
you cannot set the beacon rate to a disabled rate.
Note: UNIVERGE WL Access Points radios send
probe-response frames using the transit rates at
which they are received.
multicast-rate
{rate | auto}
Data rate of multicast frames sent by UNIVERGE
WL Access Points radios.
• rate—Sets the multicast rate to a specific rate.
The valid rates depend on the radio type and are
the same as the valid rates for mandatory.
However, you cannot set the multicast rate to a
disabled rate.
• auto—Sets the multicast rate to the highest rate
that can reach all clients connected to the
UNIVERGE WL Access Points radio.