Specifications

set service-profile transmit-rates
Chapter 12
AP Commands
363
mandatory rate-list Set of data transmission rates that clients are
required to support in order to associate with an
SSID on a UNIVERGE WL Access Point radio. A
client must support at least one of the mandatory
rates.
These rates are advertised in the basic rate set of
802.11 beacons, probe responses, and reassociation
response frames sent by UNIVERGE WL Access
Points radios.
Data frames and management frames sent by
UNIVERGE WL Access Points radios use one of the
specified mandatory rates.
The valid rates depend on the radio type:
• 11a—6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
• 11b—1.0, 2.0, 5.5, 11.0
• 11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0,
36.0, 48.0, 54.0
Use a comma to separate multiple rates; for
example: 6.0,9.0,12.0
disabled rate-list Data transmission rates that UNIVERGE WL
Access Points radios do not use to transmit data.
This setting applies only to data sent by the
UNIVERGE WL Access Points radios. The radios
still accepts frames from clients at disabled data
rates.
The valid rates depend on the radio type and are the
same as the valid rates for mandatory.