Specifications

set service-profile tkip-mc-time
Chapter 12
AP Commands
361
l For traffic from clients to the network, the UNIVERGE WL Access Points
marks the DSCP value in the IP headers of the tunnel packets used to carry the
user data from the UNIVERGE WL Access Points to the UNIVERGE WL
Controller.
Syntax set service-profile name static-cos {enable | disable}
Defaults Static CoS is disabled by default.
Access Enabled.
Usage The CoS level is specified by the set service-profile cos command. The
default static CoS level is 0 (low priority).
Examples The following command enables static CoS on service profile sp1:
PROPMT# set service-profile sp1 static-cos enable
success: change accepted.
See Also
l set service-profile cos on page 347
l show service-profile on page 413
set service-profile tkip-mc-time
Changes the length of time that UNIVERGE WL Access Points radios use
countermeasures if two message integrity code (MIC) failures occur within 60
seconds. When countermeasures are in effect, UNIVERGE WL Access Points
radios dissociate all TKIP and WPA WEP clients and refuse all association and
reassociation requests until the countermeasures end.
name Service profile name.
enable Enables static CoS on the service profile.
disable Disables static CoS on the service profile.