Specifications

set system contact
Chapter 4
System Services Commands
32
See Also
l clear prompt on page 23
l set system name on page 38
l show config on page 600
set system contact
Stores a contact name for the UNIVERGE WL Controller.
Syntax set system contact string
Defaults None.
Access Enabled.
To view the system contact string, type the show system command.
Examples The following command sets the system contact information to
[e-mail]:
Controller#set system contact [e-mail]
success: change accepted.
See Also
l clear system on page 23
l set system location on page 37
l set system name on page 38
l show system on page 40
string Alphanumeric string up to 256 characters long. (blank spaces
are available to input.)