Specifications

set service-profile idle-client-probing

Chapter 12

AP Commands

349

set service-profile idle-client-probing

Disables or reenables periodic keepalives from UNIVERGE WL Access Points

radios to clients on a service profile’s SSID. When idle-client probing is enabled,

the UNIVERGE WL Access Points radio sends a unicast null-data frame to each

client every 10 seconds. Normally, a client that is still active sends an Ack in reply

to the keepalive.

If a client does not send any data or respond to any keepalives before the user idle

timeout expires, UNIVERGE WL Control System changes the client session to

the Disassociated state.

Syntax

set service-profile name idle-client-probing {enable | disable}

Defaults

Idle-client probing is enabled by default.

Access

Enabled.

Usage

The length of time a client can remain idle (unresponsive to idle-client

probes) is specified by the user-idle-timeout command.

Examples

The following command disables idle-client keepalives on service

profile sp1:

PROPMT# set service-profile sp1 idle-client-probing disable

success: change accepted.