Specifications

set service-profile dhcp-restrict

Chapter 12

AP Commands

348

set service-profile dhcp-restrict

Enables or disables DHCP Restrict on a service profile. DHCP Restrict filters the

traffic from a newly associated client and allows DHCP traffic only, until the

client has been authenticated and authorized. All other traffic is captured by the

UNIVERGE WL Controller and is not forwarded. After the client is successfully

authorized, the traffic restriction is removed.

Syntax

set service-profile name dhcp-restrict {enable | disable}

Defaults

DHCP Restrict is disabled by default.

Access

Enabled.

Usage

To further reduce the overhead of DHCP traffic, use the set

service-profile no-broadcast command to disable DHCP broadcast traffic from

UNIVERGE WL Access Points radios to clients on the service profile’s SSID.

Examples

The following command enables DHCP Restrict on service profile sp1:

PROPMT# set service-profile sp1 dhcp-restrict enable

success: change accepted.