Specifications

set service-profile cos

Chapter 12

AP Commands

347

See Also

l set service-profile cipher-ccmp on page 343

l set service-profile cipher-tkip on page 343

l set service-profile cipher-wep104 on page 344

l set service-profile wep key-index on page 371

l set service-profile wpa-ie on page 372

l show service-profile on page 413

set service-profile cos

Sets the Class-of-Service (CoS) level for static CoS.

Syntax

set service-profile name cos level

Defaults

The default static CoS level is 0.

Access

Enabled.

Usage

This command applies only when static CoS is enabled. If static CoS is

disabled, prioritization is based on the QoS mode configured in the radio profile,

and on any ACLs that set CoS. (See the “Configuring Quality of Service” chapter

of the Configuration Guide.) To enable static CoS, use the set service-profile

static-cos command.

Examples

The following command changes the static CoS level to 7 (voice

priority):

PROPMT# set service-profile sp1 cos 7

success: change accepted.