Specifications

set service-profile cipher-ccmp
Chapter 12
AP Commands
343
set service-profile cipher-ccmp
Enables Counter with Cipher Block Chaining Message Authentication Code
Protocol (CCMP) encryption with WPA clients, for a service profile.
Syntax set service-profile name cipher-ccmp {enable | disable}
Defaults CCMP encryption is disabled by default.
Access Enabled.
Usage To use CCMP, you must also enable the WPA IE.
Examples The following command configures service profile sp2 to use CCMP
encryption:
PROPMT# set service-profile sp2 cipher-ccmp enable
success: change accepted.
See Also
l set service-profile cipher-tkip on page 343
l set service-profile cipher-wep104 on page 344
l set service-profile cipher-wep40 on page 346
l set service-profile wpa-ie on page 372
l show service-profile on page 413
set service-profile cipher-tkip
Disables or reenables Temporal Key Integrity Protocol (TKIP) encryption in a
service profile.
name Service profile name.
enable Enables CCMP encryption for WPA clients.
disable Disables CCMP encryption for WPA clients.