Specifications

set service-profile beacon

Chapter 12

AP Commands

340

See Also

l set service-profile auth-dot1x on page 336

l set service-profile psk-raw on page 355

l set service-profile wpa-ie on page 372

l show service-profile on page 413

set service-profile beacon

Disables or reenables beaconing of the SSID managed by the service profile.

A UNIVERGE WL Access Point radio responds to an 802.11 probe any request

with only the beaconed SSID(s). For a nonbeaconed SSID, radios respond only to

directed 802.11 probe requests that match the nonbeaconed SSID’s SSID string.

When you disable beaconing for an SSID, the radio still sends beacon frames, but

the SSID name in the frames is blank.

Syntax

set service-profile name beacon {enable | disable}

Defaults

Beaconing is enabled by default.

Access

Enabled.

Examples

The following command disables beaconing of the SSID managed by

service profile sp2:

PROPMT# set service-profile sp2 beacon disable

success: change accepted.