Specifications

set service-profile auth-fallthru
Chapter 12
AP Commands
337
If you disable 802.1X authentication of WPA clients, the only method available
for authenticating the clients is preshared key (PSK) authentication. To use this,
you must enable PSK support and configure a passphrase or key.
Examples The following command disables 802.1X authentication for WPA
clients that use service profile wpa_clients:
PROPMT# set service-profile wpa_clients auth-dot1x disable
success: change accepted.
See Also
l set service-profile auth-psk on page 339
l set service-profile psk-phrase on page 354
l set service-profile wpa-ie on page 372
l show service-profile on page 413
set service-profile auth-fallthru
Specifies the authentication type for users who do not match an 802.1X or MAC
authentication rule for an SSID managed by the service profile. When a user tries
to associate with an SSID, UNIVERGE WL Control System checks the
authentication rules for that SSID for a userglob that matches the username. If the
SSID does not have an authentication rule that matches the username,
authentication for the user falls through to the fallthru type.
The fallthru type is a service profile parameter, and applies to all radios within the
radio profiles that are mapped to the service profile.
Syntax set service-profile name auth-fallthru
{last-resort | none | web-portal}