Specifications

set service-profile active-call-idle-timeout
Chapter 12
AP Commands
333
l set service-profile wep active-unicast-index on page 370
l set service-profile wep key-index on page 371
l set service-profile wpa-ie on page 372
l show radio-profile on page 408
l show service-profile on page 413
set service-profile active-call-idle-timeout
Changes the number of seconds UNIVERGE WL Control System will continue to
reserve bandwidth for an active voice session (on-hook call). If the timer expires,
the radio releases the bandwidth that was reserved for the session.
The timer is reset to 0 each time a client sends data or reregisters with its SIP
server.
Syntax set service-profile name active-call-idle-timeout seconds
Defaults The default active-call idle timeout is 120 seconds (2 minutes).
Access Enabled.
name Service profile name.
seconds Number of seconds an on-hook client is allowed to
remain idle before the radio UNIVERGE WL
Control System releases the bandwidth reserved for
the session. You can specify from 20 to 300 seconds.
To disable the timer, specify 0.
UNIVERGE WL Control System resets the timer by
keepaliving between UNIVERGE WL Access
Points and client.
If you specify less than 60, active-call-idle-timeout
happens, before the keepalive packets reach.And
then bandwidth might release.
UNIVERGE WL Control System recommends that
you do not specify less than 60.