Specifications

set radio-profile service-profile
Chapter 12
AP Commands
331
Access Enabled.
Usage You must configure the service profile before you can map it to a radio
profile. You can map the same service profile to more than one radio profile.
You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command
.
Examples The following command maps service-profile wpa_clients to radio
profile rp2:
PROPMT# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
l set service-profile active-call-idle-timeout on page 333
l set service-profile attr on page 334
l set service-profile auth-dot1x on page 336
l set service-profile auth-fallthru on page 337
l set service-profile auth-psk on page 339
l set service-profile beacon on page 340
l set service-profile cac-mode on page 341
wep
active-multicast-index
1 Uses WEP key 1 for static
WEP encryption of multicast
traffic if WEP encryption is
enabled and keys are defined.
wep active-unicast-index 1 Uses WEP key 1 for static
WEP encryption of unicast
traffic if WEP encryption is
enabled and keys are defined.
wpa-ie disable Does not use the WPA IE in
transmitted frames.
Table 34. Defaults for Service Profile Parameters
Parameter Default Value
Radio Behavior When
Parameter Set To Default
Value