Specifications

set radio-profile mode
Chapter 12
AP Commands
317
Table 33. Defaults for Radio Profile Parameters
Parameter
Default
Value
Radio Behavior When
Parameter Set To Default
Value
active-scan enable Sends probe any requests (probe
requests with a null SSID name)
to solicit probe responses from
other access points.
auto-tune enable Allows dynamic configuration
of channel and power settings by
UNIVERGE WL Control
System.
beacon-interval 100 Waits 100 ms between beacons.
countermeasures Not
configured
Does not issue countermeasures
against any device.
dtim-interval 1 Sends the delivery traffic
indication map (DTIM) after
every beacon.
frag-threshold 2346 Uses the short-retry-count for
frames shorter than 2346 bytes
and uses the long-retry-count for
frames that are 2346 bytes or
longer.
max-rx-lifetime 2000 Allows a received frame to stay
in the buffer for up to 2000 ms
(2 seconds).
max-tx-lifetime 2000 Allows a frame that is scheduled
for transmission to stay in the
buffer for up to 2000 ms
(2 seconds).