Specifications
set radio-profile auto-tune power-interval
Chapter 12
AP Commands
306
set radio-profile auto-tune power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the power
level on radios in a radio profile. At the end of each interval, UNIVERGE WL
Control System processes the results of the RF scans performed during the
previous interval, and changes radio power levels if needed.
Syntax
set radio-profile name auto-tune power-interval seconds
Defaults
The default power tuning interval is 300 seconds.
Access
Enabled.
Examples
The following command sets the power interval for radios in radio
profile rp2 to 240 seconds:
PROPMT# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
See Also
l set ap radio auto-tune max-power on page 292
l set radio-profile auto-tune power-config on page 305
l show service-profile on page 413
name Radio profile name.
seconds Number of seconds UNIVERGE WL Control System waits
before changing radio power levels to adjust to RF changes,
if needed. You can specify from 1 to 65535 seconds.