Specifications

set auto-config
Chapter 4
System Services Commands
27
Usage A network administrator at the corporate office can preconfigure the
UNIVERGE WL Controller in a WLMS network plan. The UNIVERGE WL
Controller configuration must have a name for the UNIVERGE WL Controller,
the serial number must match the UNIVERGE WL Controller’s serial number.
The configuration should also include all other settings required for the
deployment, including UNIVERGE WL Access Points configuration, SSIDs,
AAA settings, and so on.
When the WLMS server in the corporate network receives the configuration
request, the server looks in the currently open network plan for a UNIVERGE WL
Controller configuration with the same model and serial number as the one in the
configuration request.
l If the network plan contains a configuration with a matching model and serial
number, WLMS sends the configuration to the UNIVERGE WL Controller
and restarts the UNIVERGE WL Controller. The UNIVERGE WL Controller
boots using the configuration it received from WLMS.
l If the network plan does not have a configuration with a matching model and
serial number, a verification warning appears in WLMS. The warning lists the
UNIVERGE WL Controller’s serial number and IP address. The network
administrator can upload the UNIVERGE WL Controller into the network
plan, configure UNIVERGE WL Controller parameters, and deploy the
configuration to the UNIVERGE WL Controller.
UNIVERGE WL Controller model to be able to access a WLMS server for a
configuration, you also must preconfigure the UNIVERGE WL Controller with
the following information:
l IP address
l Default router (gateway) address
l Domain name and DNS server address
You can enable the UNIVERGE WL Controller to use the UNIVERGE WL
Control System DHCP client to obtain this information from a DHCP server in the
local network where the UNIVERGE WL Controller will be deployed.
Alternatively, you can statically configure the information.