Specifications
set radio-profile auto-tune power-config
Chapter 12
AP Commands
305
set radio-profile auto-tune power-config
Enables or disables dynamic power tuning (RF Auto-Tuning) for the UNIVERGE
WL Access Points radios in a radio profile.
Syntax
set radio-profile name auto-tune power-config {enable | disable}
Defaults
Dynamic power assignment is disabled by default.
Access
Enabled.
Usage
When RF Auto-Tuning for power is disabled, UNIVERGE WL Control
System does not dynamically set the power levels when radios are first enabled
and also does not tune power during operation with associated clients.
When RF Auto-Tuning for power is enabled, UNIVERGE WL Control System
does not allow you to manually change the power level.
Examples
The following command enables dynamic power tuning for radios in
the rp2 radio profile:
PROPMT# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
See Also
l set ap radio auto-tune max-power on page 292
l set radio-profile auto-tune channel-config on page 301
l set radio-profile auto-tune power-interval on page 306
l show radio-profile on page 408
name Radio profile name.
enable Configures radios to dynamically set their power levels
when the UNIVERGE WL Access Points are started.
disable Configures radios to use their statically assigned power
levels, or the default power levels if unassigned, when the
radios are started.