Specifications

set radio-profile auto-tune channel-interval
Chapter 12
AP Commands
304
set radio-profile auto-tune channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the
channels on radios in a radio profile. At the end of each interval, UNIVERGE WL
Control System processes the results of the RF scans performed during the
previous interval, and changes radio channels if needed.
Syntax set radio-profile name auto-tune channel-interval seconds
Defaults The default channel interval is 3600 seconds (one hour).
Access Enabled.
Usage It is recommended to use an interval of at least 300 seconds (5 minutes).
RF Auto-Tuning can change a radio channel before the channel interval expires in
response to RF anomalies. Even in this case, channel changes cannot occur more
frequently than the channel holddown interval.
If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at
regular intervals. However, RF Auto-Tuning can still change the channel in
response to RF anomalies.
Examples The following command sets the channel interval for radios in radio
profile rp2 to 2700 seconds (45 minutes):
PROPMT# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
See Also
l set radio-profile auto-tune channel-config on page 301
l set radio-profile auto-tune channel-holddown on page 303
l show radio-profile on page 408
name Radio profile name.
seconds Number of seconds RF Auto-Tuning waits before changing
radio channels to adjust to RF changes, if needed. You can
specify from 0 to 65535 seconds.