Specifications

set radio-profile auto-tune channel-config
Chapter 12
AP Commands
301
Syntax set radio-profile name active-scan {enable | disable}
Defaults Active scanning is enabled by default.
Access Enabled.
Usage You can enter this command on any UNIVERGE WL Controller in the
Mobility Domain. The command takes effect only on that UNIVERGE WL
Controller.
Examples The following command disables active scan in radio profile radprof3:
PROPMT# set radio-profile radprof3 active-scan disable
success: change accepted.
See Also show radio-profile on page 408
set radio-profile auto-tune channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the
UNIVERGE WL Access Points radios in a radio profile.
Syntax set radio-profile name auto-tune channel-config {enable | disable}
[no-client]
name Radio profile name.
enable Configures radios to actively scan for rogues.
disable Configures radios to scan only passively for rogues by
listening for beacons and probe responses.
name Radio profile name.
enable Configures radios to dynamically select their channels when
the radios are started.
disable Configures radios to use their statically assigned channels,
or the default channels if unassigned, when the radios are
started.
no-client Configures radios to change channels regardless of client
status. Without this option, a radio changes the channel only
if the radio does not have any active clients on that channel.