Specifications

set ap upgrade-firmware
Chapter 12
AP Commands
300
set ap upgrade-firmware
Disables or reenables automatic upgrade of an AP boot firmware.
Syntax set ap auto upgrade-firmware {enable | disable}
Defaults Automatic firmware upgrades of AP are enabled by default.
Access Enabled.
Usage When the feature is enabled on a UNIVERGE WL Controller port, an AP
connected to that port upgrades its boot firmware to the latest version stored on
the UNIVERGE WL Controller.
Examples The following command disables automatic firmware upgrades on the
AP 3:
PROPMT# set ap 3 upgrade-firmware disable
See Also show ap config on page 374
set radio-profile active-scan
Disables or reenables active RF detection scanning on the UNIVERGE WL
Access Points radios managed by a radio profile. When active scanning is
enabled, UNIVERGE WL Access Points radios look for rogue devices by sending
probe any requests (probe requests with a null SSID name), to solicit probe
responses from other access points.
Passive scanning is always enabled and cannot be disabled. During passive
scanning, radios look for rogues by listening for beacons and probe responses.
ap auto Configures firmware upgrades for the UNIVERGE WL
Access Points configuration profile. (See set ap auto on
page 277.)
enable Enables automatic firmware upgrades.
disable Disables automatic firmware upgrades.