Specifications

set ap security
Chapter 12
AP Commands
298
Examples The following command configures the transmit power on the 802.11a
radio on the AP connected 3:
PROPMT# set ap 3 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on the
802.11b/g radio on the AP 1:
PROPMT# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
l set ap radio channel on page 293
l show ap config on page 374
set ap security
Sets security requirements for management sessions between a UNIVERGE WL
Controller and its UNIVERGE WL Access Points.
Syntax set ap security secsetting {require | optional | none}
Note. The maximum transmission unit (MTU) for encrypted UNIVERGE WL
Access Points management traffic is 1498 bytes, whereas the MTU for
unencrypted management traffic is 1474 bytes. Make sure the devices in the
intermediate network between the UNIVERGE WL Controller and UNIVERGE WL
Access Points can support the higher MTU.
security secsetting Name of the security security setting.
require Requires all UNIVERGE WL Access Points to have
encryption keys that have been verified in the CLI by an
administrator. If a UNIVERGE WL Access Point does not
have an encryption key or the key has not been verified, the
UNIVERGE WL Controller does not establish a
management session with the UNIVERGE WL Access
Points.