Specifications

set ap radio mode
Chapter 12
AP Commands
295
set ap radio mode
Enables or disables a radio on an AP.
Syntax set ap {ap-number | auto} radio {1 | 2} mode {enable | disable}
Defaults AP access point radios are disabled by default.
Access Enabled.
Usage To enable or disable one or more radios to which a profile is assigned, use
the set ap radio radio-profile command. To enable or disable all radios that use a
specific radio profile, use the set radio-profile command.
Examples The following command enables radio 1 on the AP 1:
PROPMT# set ap 1 radio 1 mode enable
success: change accepted.
See Also
l clear ap radio on page 271
l set ap radio radio-profile on page 296
l set radio-profile mode on page 316
l show ap config on page 374
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
ap auto Sets the radio mode for UNIVERGE WL Access Points
managed by the UNIVERGE WL Access Points
configuration profile. (See set ap auto on page 277.)
radio 1 Radio 1 of the UNIVERGE WL Access Points.
radio 2 Radio 2 of the UNIVERGE WL Access Points. (This option
does not apply to single-radio models.)
mode enable Enables a radio.
mode disable Disables a radio.