Specifications

set ap radio channel
Chapter 12
AP Commands
293
Defaults The default maximum power setting that RF Auto-Tuning can set on a
radio is the highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Access Enabled.
Examples The following command sets the maximum power that
RF Auto-Tuning can set on radio 1 on the UNIVERGE WL Access Points 3 to
12 dBm.
PROPMT# set ap 3 radio 1 auto-tune max-power 12
success: change accepted.
See Also
l set radio-profile auto-tune power-config on page 305
l set radio-profile auto-tune power-interval on page 306
set ap radio channel
Sets an AP radio channel.
Syntax set ap ap-number radio {1 | 2} channel channel-number
radio 2 Radio 2 of the UNIVERGE WL Access Points.
(This option does not apply to single-radio
models.)
power-level Maximum power setting RF Auto-Tuning can
assign to the radio, expressed as the number of
decibels in relation to 1 milliwatt (dBm). You can
specify a value from 1 up to the maximum value
allowed for the country of operation.
The power-level can be a value from 1 to 20.
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
radio 1 Radio 1 of the UNIVERGE WL Access Points.