Specifications

set ap radio auto-tune max-power
Chapter 12
AP Commands
292
Defaults All radios use the internal antenna by default, if the UNIVERGE WL
Access Points model has an internal antenna.
Access Enabled.
Examples The following command configures the 802.11b/g radio on
UNIVERGE WL Access Points 1 to use antenna model WL-ANT2060:
PROPMT# set ap 1 radio 1 antennatype WL-ANT2060
success: change accepted.
See Also show ap config on page 374
set ap radio auto-tune max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax set ap {ap-number | auto} radio {1 | 2} auto-tune max-power
power-level
antennatype
{ANT5060 | ANT5120 |
ANT5180 | WL-ANT5060 |
WL-ANT5120 | WL-ANT5180 |
internal}
802.11a external antenna models:
• ANT5060—60° 802.11a antenna
• ANT5120—120° 802.11a antenna
• ANT5180—180° 802.11a antenna
• WL-ANT5060—60° 802.11a antenna
• WL-ANT5120—120° 802.11a antenna
• WL-ANT5180—180° 802.11a antenna
• internal—Uses the internal antenna
instead
ap ap-number Index value that identifies the UNIVERGE WL
Access Points on the UNIVERGE WL Controller.
ap auto Sets the maximum power for radios configured by
the UNIVERGE WL Access Points configuration
profile. (See set ap auto on page 277.)
radio 1 Radio 1 of the UNIVERGE WL Access Points.