Specifications

set ap radio antennatype
Chapter 12
AP Commands
291
Examples The following command changes the name of the AP 1 to techpubs:
PROPMT# set ap 1 name techpubs
success: change accepted.
See Also show ap config on page 374
set ap radio antennatype
Sets the model number for an external antenna.
set ap ap-number radio {1 | 2} antennatype {ANT1060 | ANT1120 |
ANT1180 | WL-ANT2060 | WL-ANT2120 | WL-ANT2180 | ANT5060
|ANT5060 | ANT5120 | ANT5180 | WL-ANT5060 | WL-ANT5120 | WL-ANT5180 |
internal}
ap ap-number Index value that identifies the UNIVERGE
WL Access Points on the UNIVERGE WL
Controller.
radio 1 Radio 1 of the UNIVERGE WL Access
Points.
radio 2 Radio 2 of the UNIVERGE WL Access
Points. (This option does not apply to
single-radio models.)
antennatype
{ANT1060 | ANT1120 |
ANT1180 | WL-ANT2060 |
WL-ANT2120 | WL-ANT2180 |
internal}
802.11b/g external antenna models:
• ANT1060—60° 802.11b/g antenna
• ANT1120—120° 802.11b/g antenna
• ANT1180—180° 802.11b/g antenna
• WL-ANT2060—60° 802.11b/g
antenna
• WL-ANT2120—120° 802.11b/g
antenna
• WL-ANT2180—180° 802.11b/g
antenna
• internal—Uses the internal antenna
instead