Specifications

set ap force-image-download
Chapter 12
AP Commands
289
If a UNIVERGE WL Access Point is already installed and operating, you can use
the show ap status command to display the fingerprint. The show ap config
command lists the UNIVERGE WL Access Point fingerprint only if the
fingerprint has been verified in UNIVERGE WL Control System. If the
fingerprint has not been verified, the fingerprint information in the command
output is blank.
Examples The following example verifies the fingerprint for UNIVERGE WL
Access Points 8:
PROPMT# set ap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
See Also
l set ap security on page 298
l show ap config on page 374
l show ap group on page 389
set ap force-image-download
Configures a UNIVERGE WL Access Point to download its software image from
the UNIVERGE WL Controller instead of loading the image that is locally stored
on the UNIVERGE WL Access Point.
Syntax set ap auto force-image-download {enable | disable}
Defaults Forced image download is disabled by default.
Access Enabled.
ap auto Configures forced image download for the UNIVERGE WL
Access Point configuration profile. (See set ap auto on
page 277.)
force-image-
download enable
Enables forced image download.
force-image-
download disable
Disables forced image download.