Specifications

set ap fingerprint
Chapter 12
AP Commands
288
See Also
l clear ap boot-configuration on page 273
l set ap boot-configuration ip on page 284
l set ap boot-configuration switch on page 285
l show ap boot-configuration on page 401
set ap fingerprint
Verifies a UNIVERGE WL Access Point fingerprint on a UNIVERGE WL
Controller. If UNIVERGE WL Access Points-UNIVERGE WL Controller
security is required by a UNIVERGE WL Controller, a UNIVERGE WL Access
Point can establish a management session with the UNIVERGE WL Controller
only if you have verified the UNIVERGE WL Access Point identity by verifying
its fingerprint on the UNIVERGE WL Controller.
Syntax set ap ap-number fingerprint fingerprint
Defaults None.
Access Enabled.
Usage UNIVERGE WL Access Points are configured with an encryption key
pair at the factory. The fingerprint for the public key is displayed on a label on the
back of the UNIVERGE WL Access Points, in the following format:
RSA
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
fingerprint The 16-digit hexadecimal number of the fingerprint. Use a
colon between each digit. Make sure the fingerprint you
enter matches the fingerprint used by the UNIVERGE WL
Access Points.