Specifications

help

Chapter 4

System Services Commands

l show system on page 40

help

Displays a list of commands that can be used to configure and monitor the

UNIVERGE WL Controller.

Syntax

help

Defaults

None.

Access

All.

Examples

Use this command to see a list of available commands. If you have

restricted access, you see fewer commands than if you have enabled access. To

display a list of CLI commands available at the enabled access level, type the

following command at the enabled access level:

PROMPT# help

Commands:

--------------------------------------------------------------------

clear Clear, use 'clear help' for more information

commit Commit the content of the ACL table

copy Copy from filename (or url) to filename (or url)

crypto Crypto, use 'crypto help' for more information

delete Delete url

dir Show list of files on flash device

disable Disable privileged mode

exit Exit from the Admin session

help Show this help screen

history Show contents of history substitution buffer

load Load, use 'load help' for more information

logout Exit from the Admin session

monitor Monitor, use 'monitor help' for more information

ping Send echo packets to hosts

quit Exit from the Admin session

reset Reset, use 'reset help' for more information

rollback Remove changes to the edited ACL table

save Save the running configuration to persistent storage

set Set, use 'set help' for more information

show Show, use 'show help' for more information

telnet telnet IP address [server port]

traceroute Print the route packets take to network host