Specifications

set ap boot-configuration switch
Chapter 12
AP Commands
285
If the manually assigned IP information is incorrect, the UNIVERGE WL Access
Points uses DHCP to obtain its IP address.
Examples The following command configures UNIVERGE WL Access Points 1
to use IP address 172.16.0.42 with a 24-bit netmask, and use 172.16.0.20 as its
default gateway:
PROPMT# set ap 1 boot-configuration ip 172.16.0.42 netmask 255.255.255.0 gateway
172.16.0.20
success: change accepted.
See Also
l clear ap boot-configuration on page 273
l set ap boot-configuration switch on page 285
l set ap boot-configuration vlan on page 287
l show ap boot-configuration on page 401
set ap boot-configuration switch
Specifies the UNIVERGE WL Controller that a UNIVERGE WL Access Points
contacts and attempts to use as its boot device.
Syntax set ap ap-number boot-configuration switch [switch-ip ip-addr] [name
name dns ip-addr] [mode {enable | disable}]
ap ap-number Index value that identifies the UNIVERGE WL
Access Points on the UNIVERGE WL Controller.
switch-ip ip-addr The IP address of the UNIVERGE WL Controller
the UNIVERGE WL Access Points should boot
from.
name name The fully qualified domain name of the
UNIVERGE WL Controller that the UNIVERGE
WL Access Points boots from. When both a name
and a switch-ip are specified, the UNIVERGE WL
Access Points uses the name.