Specifications

set ap boot-configuration ip
Chapter 12
AP Commands
284
Defaults LED blink mode is disabled by default.
Access Enabled.
Usage Changing the LED blink mode does not alter operation of the AP. Only
the behavior of the LEDs is affected.
Examples The following command enables LED blink mode on the AP 3 and 4:
PROPMT# set ap 3-4 blink enable
success: change accepted.
set ap boot-configuration ip
Specifies static IP address information for a UNIVERGE WL Access Points.
Syntax set ap ap-number boot-configuration ip ip-addr netmask mask-addr
gateway gateway-addr [mode {enable | disable}]
Defaults By default UNIVERGE WL Access Points use DHCP to obtain an IP
address, rather than a using a manually assigned IP address.
Access Enabled.
Usage Normally, UNIVERGE WL Access Points use DHCP to obtain IP address
information. In some installations, DHCP may not be available. In this case, you
can assign static IP address information to the UNIVERGE WL Access Points,
including the UNIVERGE WL Access Point IP address and netmask, and default
gateway.
ap ap-number Index value that identifies the UNIVERGE WL
Access Points on the UNIVERGE WL Controller.
ip ip-addr The IP address to be assigned to the UNIVERGE
WL Access Points, in dotted decimal notation (for
example, 10.10.10.10).
netmask mask-addr The subnet mask, in dotted decimal notation (for
example, 255.255.255.0).
gateway gateway-addr The IP address of the next-hop router, in dotted
decimal notation.
mode {enable | disable} Enables or disables the static IP address for the
UNIVERGE WL Access Points.