Specifications

set ap bias
Chapter 12
AP Commands
282
l set ap auto on page 277
l set ap auto mode on page 279
l set ap auto persistent on page 280
set ap bias
Changes the bias for a UNIVERGE WL Access Point. Bias is the priority of one
UNIVERGE WL Controller over other UNIVERGE WL Controllers for booting
and configuring the UNIVERGE WL Access Points.
Syntax set ap {ap-number | auto} bias {high | low}
Defaults The default bias is high.
Access Enabled.
Usage High bias is preferred over low bias. Bias applies only to UNIVERGE
WL Controllers indirectly attached to the UNIVERGE WL Access Points through
an intermediate Layer 2 or Layer 3 network. A UNIVERGE WL Access Point
always attempts to boot on UNIVERGE WL Access Points port 1 first, and if a
UNIVERGE WL Controller is directly attached on UNIVERGE WL Access
Points port 1, the UNIVERGE WL Access Points always boots from it.
If UNIVERGE WL Access Points port 1 is indirectly connected to UNIVERGE
WL Controllers through the network, the UNIVERGE WL Access Points boots
from the UNIVERGE WL Controller with the high bias for the UNIVERGE WL
Access Points. If the bias for all connections is the same, the UNIVERGE WL
Access Points selects the UNIVERGE WL Controller that has the greatest
capacity to add more active UNIVERGE WL Access Points. For example, if a
UNIVERGE WL Access Point is dual homed to two NIVERGE WL Controllers,
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
ap auto Configures bias for the UNIVERGE WL Access Points
configuration profile. (See set ap auto on page 277.)
high High bias.
low Low bias.