Specifications

set ap auto mode
Chapter 12
AP Commands
279
Examples The following command creates a profile for automatic UNIVERGE
WL Access Points configuration:
PROPMT# set ap auto
success: change accepted.
See Also
l set ap auto mode on page 279
l set ap auto persistent on page 280
l set ap auto radiotype on page 281
l set ap bias on page 282
l set ap blink on page 283
l set ap radio auto-tune max-power on page 292
l set ap radio mode on page 295
l set ap radio radio-profile on page 296
l set ap upgrade-firmware on page 300
set ap auto mode
Enables a UNIVERGE WL Controller profile for automatic UNIVERGE WL
Access Points configuration.
Syntax set ap auto mode {enable | disable}
Defaults The UNIVERGE WL Access Points configuration profile is disabled by
default.
Access Enabled.
enable Enables the UNIVERGE WL Access Points configuration
profile.
disable Disables the UNIVERGE WL Access Points configuration
profile.