Specifications

set ap auto
Chapter 12
AP Commands
278
Usage Table 31 lists the configurable profile parameters and their defaults. The
only parameter that requires configuration is the profile mode. The profile is
disabled by default. To use the profile to configure UNIVERGE WL Access
Points, you must enable the profile using the set ap auto mode enable command.
The profile uses the default radio profile by default. You can change the profile
using the set ap auto radio radio-profile command. You can use set ap auto
commands to change settings for the parameters listed in Table 31. (The
commands are listed in the “See Also” section.)
Table 31. Configurable Profile Parameters for UNIVERGE WL Access
Points
Parameter Default Value
UNIVERGE WL Access Points
Parameters
bias high
blink
(Not shown in show ap config
output)
disable
force-image-download disable (NO)
group (load balancing group) none
mode disabled
persistent none
upgrade-firmware
(boot-download-enable)
enable (YES)
Radio Parameters
radio num auto-tune
max-power
default
radio num mode enabled
radio num radio-profile default
radiotype 11g
(or 11b for country codes
where 802.11g is not allowed)