Specifications

clear service-profile
Chapter 12
AP Commands
276
The following commands disable the radios using radio profile rptest and remove
the profile:
PROPMT# set radio-profile rptest mode disable
PROPMT# clear radio-profile rptest
success: change accepted.
See Also
l set ap radio radio-profile on page 296
l set radio-profile mode on page 316
l show ap config on page 374
l show radio-profile on page 408
clear service-profile
Removes a service profile or resets one of the profile’s parameters to its default
value.
Syntax clear service-profile name
Defaults None.
Access Enabled.
Usage If the service profile is mapped to a radio profile, you must remove it from
the radio profile first. (After disabling all radios that use the radio profile, use the
clear radio-profile name service-profile name command.)
Examples The following commands disable the radios using radio profile rp6,
remove service-profile svcprof6 from rp6, then clear svcprof6 from the
configuration.
PROPMT# set radio-profile rp6 mode disable
PROPMT# clear radio-profile rp6 service-profile svcprof6
success: change accepted.
PROPMT# clear service-profile svcprof6
success: change accepted.
name Service profile name.