Specifications

clear system
Chapter 4
System Services Commands
24
Syntax clear system [contact | countrycode | idle-timeout | ip-address |
location | name]
Defaults None.
Access Enabled.
Examples To clear the location of the UNIVERGE WL Controller, type the
following command:
PROMPT# clear system location
success: change accepted.
See Also
l set system contact on page 32
l set system countrycode on page 33
l set system idle-timeout on page 35
l set system ip-address on page 36
l set system location on page 37
l show config on page 600
contact Resets the name of contact person for the UNIVERGE WL
Controller to null.
countrycode Resets the country code for the UNIVERGE WL Controller
to null.
idle-timeout Resets the number of seconds a CLI management session
can remain idle to the default value (3600 seconds).
ip-address Resets the IP address of the UNIVERGE WL Controller to
null.
location Resets the location of the UNIVERGE WL Controller to
null.
name Resets the name of the UNIVERGE WL Controller to the
default system name, which is UNIVERGE-mm-nnnnnn,
where mm is the model number and nnnnnn is the
last 6 digits of the UNIVERGE WL Controller’s MAC
address.